The dee straight curb and gutter forming system consists of a back form, a front form, a face form, a division plate, and a top spreader. The back and front forms are standard straight flatwork forms with the back form taller than the front form. The dee straight curb and gutter forms are normally assembled into a curb and gutter forming system. The profile is the important part : B profile or J profile. We stock 18" 24" 30" Skeletons or Dividers.
The 24" B profile is the most popular profile that we sell. Please review the ones below for your needs. The 6 inch clamp or top spreader bar is the standard but we can order you a custom spreader bar and or division plate if you have a detailed drawing for Dee to follow. Our division plates come with a nail hole in the top tab of the division plate. This is help full if you are using a wood back form. 36" nail stakes are generally used for the back form and 24" nail stakes are used in the front form. We stock 3/4" & 7/8" nail stakes along with 4" x1 0' side walk forms.
The dee side walk forms will save you money on material cost and save time on set up of your sidewalk job.
The B Profile is the most popular profile in the Atlanta area. It has a square type
layout and the J has a radius to it. This profile is where the water would collect and run off. We also sell the roll over division plates that you see in a subdivision.